Motion Sensor NightLight

Features:

- Three Operation Modes: On / Off / Auto. When the light is set to be "ON", it will be ON constantly. When the light is set to "AUTO", if there is an object within the 10ft of the light's detection range, the light will be on immediately. Then it will be off automatically in about 15 seconds if no motions detected.

- PIR Motion & light sensor: PIR Motion & light sensor: At dark place, it will light up automatically when you get into 3M detection range, and auto go out 15-20 seconds after you get out of the range.

-Rechargeable: Built-in 600mah lithium battery. It can last for 4 hours when fully charged at ON mode and Last 2 months at AUTO mode. Compatible with power bank, computer, laptop, battery charger, phone charger, wall charger, PC USB port;

- Easy installation: magnet, hanging slot and 3M adhesive tape, could be hung and stick-on anywhere; No tools, screws or nuts are required when installation.
 

Application:

- Suitable for stairway, drawer, under-cabinet, pantry, bedroom, wardrobe, workshop, bookshelf, attic, closet, basement, hallway, corridor, headboard, trunk lighting, etc.
 

Note:

1. Since this product has the built-in photo sensor, when it's on AUTO mode, it will only work properly in the darkness environment. Please DO NOT install the light in the bright place if you would like to take advantage of the AUTO mode feature.

2. Try not to install these lights too close to each other. Because They may interact each other and will not work properly on AUTO mode.

3. This light IS NOT waterproofing. Please DO NOT use it in any heavy humidity or low temp locations.
 

Package:

2 x Motion Sensor Night Lights